Your Search Results

Clamp confirmation for any system, UNILOCK or otherwise, is a sound design criterion when building any workholding system.

No part or fixture is too small or too big for UNILOCK. The only limit is your imagination.

When using a mechanical milling chuck that implements a needle bearing cage the correct clamping position will vary.

Proper clamping techniques will ensure the proper operation of all mechanical milling chucks.

The concept of using guide pins to load large fixtures has been around for a long time, and it even applies when incorporating Unilock zero-point clamping systems in your fixturing.

To maintain a highly repeatable loading system, use air to clean the clamping knobs.

The is no general rule to cutting tool shank insertion as a multiplier for shank diameter. All tool holder types have different requirements.

Overall gripping strength increases as you increase the size of your tool holders (when looking at the same type of holder).

Adjusting screws are not just a simple set screw. They are a screw with a purpose—three actually.