Your Search Results

When using a high-performance drill, we do not recommend turning on coolant until the drill is inside a 1-2xD deep pilot hole.

It is sometimes difficult for users to remove collets from our MEGA nuts. Luckily we have markings on the nuts to make it easier.

When using a mechanical milling chuck that implements a needle bearing cage the correct clamping position will vary.

Adjusting screws are not just a simple set screw. They are a screw with a purpose—three actually.

When it comes to boring operations, learn when to use a ground chip-breaker vs. a molded chip-breaker.

Overall gripping strength increases as you increase the size of your tool holders (when looking at the same type of holder).

Cleanliness is key to achieving good runout control when assembling tool holders. Small particles or oil in a tool holder can cause large runout of the cutting tool, deceasing tool life and performance.

As cutting tool diameters get smaller, the acceptable amount of runout must decrease substantially.

The is no general rule to cutting tool shank insertion as a multiplier for shank diameter. All tool holder types have different requirements.