Your Search Results

In a recently published article in Manufacturing Engineering, BIG KAISER contributes to the conversations of the evolution of five-axis machines.

The new SW BIG CAPTO Rough Boring Head makes it possible to perform rough and finish boring processes.

Shops are leaving more than 30 percent of potential cutting tool life on the table by using poor-quality tool holders. With carbide costs rising, few shops can afford the waste. Learn how better tool holding improves tool life and reduces costs.

Discover how investing in the right tool holders can boost precision, extend tool life and save money in the long run.

Micromachining, cutting where the volume of chips produced with each tool path is very small, is not a high-speed operation in relation to chip load per tooth. Rather, it involves a high spindle speed due to cutter diameter. The part may be physically larger, but details of the part require ultra-small profiles achieved only by micromachining. In other words, micromachining is not limited in scope to only miniature parts.

Take the guesswork out of choosing tool holders and start getting results today.

Lead angles close to 90° more effectively combat potentially damaging chatter and vibration because they apply the least amount of radial pressure.

In a shop where speed means everything, Team Penske relies on a SPERONI tool presetter to reduce set-up times on CNCs.

As a raw material, tungsten carbide is a limited natural resource and a widely popular tool material due to its hardness and heat resistance. We can both save money by reducing the consumption of carbide and help our environment by fully utilizing every tool before recycling the rest.

This simple switch makes life much easier because it introduces more standardization to the shop floor, reduces the burden on operators, increases setup speed and dramatically reduces the chances of human error. All of which saves time and realizes return on investment – and each additional machine helps increase the rate of return.

These easy-to-use measuring devices can help protect capital machinery, prevent scrapped parts, and speed setups or programming.

As cutting tool diameters get smaller, the acceptable amount of runout must decrease substantially.

Speroni STB AEQUILIBRIA tool balancing system helps manufacturers ensure safety and performance.